Due to certain special reasons, we may need to reassemble the gearbox during its use to ensure its normal operation and work efficiency. However, many customers are prone to various problems due to a lack of knowledge in this area. In order to help everyone avoid unnecessary trouble, the editor has specially compiled relevant information. Next, we will introduce the key points of assembling reducers:
1. After cleaning the gearbox components, they can be assembled in the reverse order of disassembly.
2. During assembly, lubricating oil should be applied to the surface of rolling or sliding parts to establish preliminary lubrication conditions.
3. When installing the output shaft into the machine base, it is allowed to use a copper rod to strike the concave part and not hammer the shaft.
4. When installing the cycloidal gear, install it according to the position of the character head when disassembling.
5. Pay attention to adjusting the tightness of the reducer spring and applying grease to the oil resistant rubber sealing ring.
6. The sealing paper on the joint surface should be updated in a timely manner.
7. The bearings of the input shaft of the gearbox can be installed using the heating method.
8. When inserting the output shaft pin into the corresponding hole of the cycloidal gear, pay attention to the position of the spacer ring and use the pin sleeve to fix the position to prevent crushing of the spacer ring.
9. After the assembly of the reducer, the high-speed input shaft can be manually rotated, and it should rotate flexibly without friction or jamming; Then add lubricating oil to the gearbox until it reaches the scale line, which is complete.
The editor needs to remind everyone here that the correct method of assembling the gearbox can avoid unnecessary trouble and provide convenience for future work. Therefore, everyone must pay attention to the above content when operating.
Language
